2-2
The above figure shows a system consists of the patient monitor and its peripheral devices. The patient monitor:
Can be used for monitoring the physiological parameters, giving alarms and reviewing patient data, etc.
Supports recorder.
Supports nurse call signal, synchronization defibrillation signal, and analog output signal.
Supports Wi-Fi module, wired network, remote view, and communication with the Hypervisor Central Station
(CMS).
Supports a secondary display.
Supports AC power source and battery power source (Passport 8/cPM 8 patient monitors additionally supports
DC power source).
Supports clinical data acquisition in two formats: SD card (integral to unit) and USB drive.
The system software should support data output function, for SD card is a built-in device.
2.2 System Connections
2.2.1 Installation Support
The monitor can be mounted on a wall bracket or on a trolley support. The wall bracket or trolley support can be
ordered optionally. Each type of mounting bracket is delivered with a complete set of mounting hardware and
instructions. Refer to the documentation delivered with the mounting hardware for instructions on assembling
mounts.
CAUTION
Use mounting brackets we supply or approve. If other compatible mounting bracket is used, be sure it can
be safely used on the monitor.
The mounting bracket should be installed by our qualified service personnel, or engineers who have
adequate knowledge on it.
If other mounting solution is used, the installation personnel and the customer should verify if it can be
safely used on the monitor, and the customer will assume the responsibility for any resultant risk. This
indicates a potential hazard or unsafe practice that, if not avoided, could result in minor personal injury or
product/property damage.
To Next Page
Loading...
Need help?
General
