Mindray DC-8 EXP Service Manual

Optional Installation/Assembly 10-9
Figure 4A
2pcs of M3X8 Philips pan headed screw
Figure 4B Remove sealing cover ECG panel
of the pencil probe port
Figure 4C
ECG panel 2pcs of M3X8 Philips pan headed screw
6. As shown in the figure 5A, thread the pencil probe cable through the line hole on the bottom
base. Prevent from scratching the insulated coating when threading the cable ；as shown in
the 5B and 5C, assemble the front cover assembly and bottom base assembly, use 3 pcs of
M3X6 Philips sunk head screws and 2 pcs of M3X8 Philips pan headed screws to secure the
assemblies. Prevent from damaging the boards or any components, take care when handling
the panel appearance. Tidy the pencil probe cables, use one cable tie 3X100 to tie the pencil
probe cable onto the cable-tie bridge on the ECG base, do not tie too tightly;

Mindray DC-8 EXP Specifications

General

Brand	Mindray
Model	DC-8 EXP
Category	Medical Equipment
Language	English