5-30 Image Optimization
Display/ Hide the M-mark Line
There are 3 M-mark lines available, each with a symbol of ―A‖, ―B‖ or ―C‖ at the one
end as identification and an arrow at the other end as a mark for direction.
Perform the selection through the [Show A], [Show B] or the [Show C] item on the
touch screen, and the corresponding image will be displayed on the screen once
the related item is selected.
Touch [Display Cur.] or [Display All] on the touch screen to select whether to
display the image of the current M-mark line or all.
When there is only one M-mark line on the screen, you cannot hide it.
Switching between the M-mark Lines
To switch between the M-mark lines in Free Xros M mode.
Press <Set> to switch between the M-mark lines and press <Cursor> to show the
cursor.
The activated M-mark line will be green and the inactivated one will be white.
Adjustment of the M-mark Line
To adjust the position and angle of the M-mark line.
Position Adjustment
When the M-mark line is activated, move the trackball left and right to adjust the
position. The direction is recognized by the arrow at the end of the line.
Angle Adjustment
When the M-mark line is activated, move the trackball to adjust the fulcrum of the
line, and adjust through the [Angle] deflector rod on the control panel.
The adjusting angle range is 0-180, in increments of 1.
5.8.1.3 Exit Free Xros M
In Free Xros M mode, touch [Free Xros M] or press B or the user-defined Free Xros M key to exit
Free Xros M mode.