Battery C-1
Appendix C Battery
The battery is inside the machine; only technical
professionals from Mindray or engineers authorized by
Mindray after training can perform battery installation and
uninstallation.
If you need to change the battery or buy a new one, please
contact your sales representative.
C.1 Overview
The built-in battery is an option.
When the system is working, the battery charges when its capacity is not full, and the indicator turns
green when the capacity is full.
Generally, a completely discharged battery will fully charge in less than 8 hours.
Power off the system if you will not use the system for a long period of time (including storage/
transportation condition), and you should not allow the system in standby status, otherwise the
batteries will be out of power and permanently damaged.
The battery cannot support the ultrasound system for normal working, but only standby function.
When you need to move the ultrasound system in a hurry, you can first make the system enter the
standby mode, pull off the power plug to power the machine in standby status when moving the
machine, and then press the power button to exit standby after you move the machine to the target
position and connect the AC power.
C.2 Battery Status Indicator
The battery status indicator is located in the lower right corner of the screen, indicating the battery
capacity.
: Indicates the battery capacity is nearly empty.
: Indicates the battery capacity is full.
To Next Page
Loading...
