Mindray DC-80 - 4 Exam Preparation; Patient Information

Exam Preparation 4-1
4 Exam Preparation
You can start a patient exam in the following situations:
 New patient information: to start a new patient exam, you have to enter the patient information
first.
 New exam: to start a new exam for an already registered patient; the recorded information can
be obtained either through iStation or WorkList.
 Activate exam: select an exam that is ended within 24 hours; continue the exam with the
imported patient information and exam data.
 Continue an exam: select an exam that is paused within 24 hours; continue the exam with the
imported patient information and exam data.
General procedure for an exam:
Enter the patient information-> Select an exam mode and probe -> Choose an imaging mode ->
Start the exam.The system supports image scanning and measurement without patient information.
4.1 Patient Information
To start a new patient exam, it is better to enter the detailed patient information. The system will set
up a unique information database for each patient based on the patient information entered, so
that the information of one patient will not be confused with that of another patient.
CAUTION:
Before examining a new patient, press the <End Exam> key to end
the exam of the previous patient, and update the patient ID and
information, to avoid mixing data of the next new patient.
 To enter the Patient Info screen
 Press <Patient>, or,
 Move the cursor onto the patient information area on the main screen and press <Set> to
open the screen.
 To exit the Patient Info screen
 Click [OK] on the Patient Info screen, press <Patient> on the control panel again, or touch
[OK] on the touch screen to save the settings and exit the screen.
 Click [Cancel] on the Patient Info screen, touch [Cancel] on the touchscreen; or press
<Esc> on the control panel to exit the screen without saving any of the entered patient
data.
 Press <B> or <Freeze> to return to the current exam mode with the entered information
being saved.
 Click [Quick Register] on the screen to save the patient information quickly and return to the
main screen.