10-14 Patient Data Management
When the task management icon displays as , it means no task is undergoing or failure.
DICOM Service Setting
In the Storage Task and DICOM Print Task page, click [Service Setting] to enter the DICOM
service setting screen. For details, please refer to DICOM chapter.
Troubleshooting
If any serious error occurred like network disconnection or operation timeout, the system can
try to reconnect the network. The interval time and maximum retries can be set, for details,
please refer to DICOM chapter.
10.9 Administration
10.9.1 Access Setting
The system support two types of users: the system administrator and operator.
Administrator
The system administrator can view all patient data, such as patient information, image and
report, etc.
Operator
The operator can only view the exam information saved in the system and operated by himself
or herself, such as patient information, image and report, etc. The operator cannot view the
exam data operated by others.
10.9.2 Setting Access Control
The system administrator can preset the access control, that is, if an operator has the right to
access to the data in the system.
The access control only can be set by the system administrator.
Setting access control:
1. Open the ―Admin‖ page through the path: [Setup]→[System]→[Admin].
2. If is selected, you need to have the authority before
accessing the data. If unselected, you can access all the data without the authority.
10.9.3 System Login
If access control has been set by the system administrator, you can access the data in the system
only after you log on the system.
You need to enter user name and password in the following cases:
Before entering the system
Changing user
You need to login again after system restart or dormancy.
Log on the system:
1. The following dialogue box pops up:
To Next Page
Loading...
