17-2 System Maintenance
c) Remained stain or dust attached to surface of cable or surface of connector should
be washed out by cloth with a little soapy water, and then air-dry.
Don’t use cloth with water to clean the probe connector.
Cleaning the probe cable
a) Use soft dry cloth to wipe off stains from the probe cable.
b) If it is difficult to clean the stains thoroughly, use soft cloth dipped with mild detergent,
and then let the cable air dry.
Cleaning holders
Tool: dry soft cloth , soapy water, soft brush
Method:
Surface of power button should be cleaned by dry soft cloth. Remained stain should be
washed out by cloth with clear water or soapy water (NOTE: cloth should not be dipped
with too much water, which may cause electric shock), and then air-dry the surface.
a) Use dry soft cloth to wipe off the dust attached to inside, outside or gap of probe
holder or gel holder. As to small intra-cavity probe holder or its gap, use the soft brush
to brush the dust or stain.
b) Remained stain attached to inside, outside of holder should be washed out by cloth
with a little soapy water and then air-dry after take it out.
c) Gel warmer: Take the gel warmer out after pull out the power supply cable, use dry
soft cloth to wipe off the dust attached to inside and outside, then brush the dust in the
gel warmer or brush the stain with a little soap water and air-dry at last.
Cleaning the monitor and the touch screen
Tool: soft dry cloth ,clear water or soapy water
Method:
Surface of monitor and touch screen should be cleaned with soft dry cloth directly. Remained
stain should be washed out by cloth with a little clear water or soapy water, and then air-dry
the surface.
To Next Page
Loading...
Need help?
General
