9
6 Select Probe and Exam Mode
After directly connecting a probe or connecting probes via the probe extend module,
you can:
Select the exam mode (when only one probe is connected):
(1) Press to open the exam switching dialogue box.
(2) Roll the trackball and press <Set> to select the exam mode.
Select the exam mode and probe (when more than one probe are connected):
(1) Press to open the exam and probe switching dialog box.
(2) Roll the trackball and press <Set> to select the exam mode, and use the
left/right keys of the soft menu controls to switch the probe.
To Next Page
Loading...
