Mindray M7Vet - Cine Review

31
20 Cine Review
The system supports manual review as well as automatic review so as to review
stored images.
 Review Cine Images
1.
Press the key to freeze an image (set “Entrance When Frozen” as “Cine”
via “press
→ [System Preset] → [Image Preset]”), and the system
automatically enters the manual cine review.
2.
Roll the trackball to change the direction and speed.
3.
Click [Auto Play] on the soft menu to start the auto cine review and adjust the
speed.
4.
Roll the trackball to change the auto review to manual review.
5.
Press the <Cine> key or key to exit the cine review.
 Set an Auto Cine Review Series (Cine Clip)
1.
Set first frame: Manually review the images until the frame which you want to set
it as start point, and then click [Set First Frame] to set it as the start point.
2.
Set end frame: Manually review the images until the frame which you want to set
it as end point, and then click [Set End Frame] to set it as the end point.
3.
Use the soft menu control to click [Auto Play] to set the value (except 0), then the
system enters the auto cine status, and use this control to adjust speed.
4.
Click [Auto Play] again or roll the trackball to enter manual review status; or press
<Cine> to exit cine reviewing.
5.
Click [Skip to First]/ [Skip to Last] to review the first or last image.
6.
Click [Save Cine] in the soft menu to save the cine images of the set region.
 Cine Compare
1.
Open a cine file to enter the cine review status.
2.
Click [Cine Compare] to be "On" to enter the window of different frames.
3.
Roll the trackball or rotate the multifunctional knob to review the images; switch
the window by pressing
.
4.
Click [Cine Compare] again to exit cine compare or press to exit cine
review state.
Tips: cine compare can only be performed on single-format 2D images only.