Minelab Explorer - Editing Patterns; Editing and Saving Target Patterns Tutorial

THE MINELAB EXPLORER
77
ADVANCED USE
6
PHASE 1: Preparing for editing
STEP 1 Choose SELECT from the Main Menu and press the top
right shift button to CLEAR the Smartfind thumbnail
display.
STEP 2 (Figure 6.8) Move down the target list and accept
JEWELRY and reject FOIL to establish an initial
discrimination pattern.
STEP 3 Press the Main Menu shortcut button and select DISPLAY.
STEP 4 (Figure 6.9) Select EDIT to show the ADVANCED-EDIT
screen. It is now possible to change the existing
discrimination pattern.
PHASE 2: Resizing and moving the target frame
STEP 5 (Figure 6.10) To change the size of the target frame, press
the top left shift button to switch between Edit’s three
target frame sizes. (For the purposes of this tutorial,
please choose the medium-sized frame).
STEP 6 To move the target frame, press the shift buttons next to
the display’s navigation arrows. Position the resized frame
over the screen section you wish to edit (in the location
approximated in Figure 6.10).
Continued next page...
tutorial
*
This tutorial builds upon what has been covered in earlier
target tutorials. The tutorial’s four phases outline the steps
necessary to edit and save a preselected discrimination
pattern.
Figure 6.9 Edit screen
Figure 6.8 Discrimination pattern for jewelry
(excluding foil)
EDITING AND SAVING TARGET PATTERNS
Figure 6.9 Edit screen with small target
frame
Figure 6.8 Select option
EDITING AND SAVING TARGET PATTERNS
Figure 6.10 Edit screen with target crosshair
and medium target frame
THE MINELAB EXPLORER
76
ADVANCED USE
6
www.minelab.com
Figure 6.7 Edit screen with target frame
EDITING PATTERNS
Edit makes it possible to customize an existing discrimination pattern to match your
preferred target characteristics.
Introducing Edit
Figure 6.7
Main Menu > Options > EDIT
As described earlier in this chapter, Advanced mode’s LEARN
display allows you to accept or reject a target and create your own
discrimination patterns.
EDIT offers a final enhancement to these targeting features,
enabling you to make manual changes to any discrimination
pattern.
For example: Learn mode’s target selection may not provide quite
the result you wanted (even when using a different-sized cursor)
Rather than start all over again, you can just ‘touch up’ your
results. Similarly, you may find that the discrimination pattern for
FOIL may need to be modified to suit your requirements.
The following tutorial outlines how to edit and then save
discrimination patterns.
NOTE Make sure Pinpoint is in OFF position before using
EDIT to customize your discrimination pattern.
EDITING PATTERNS