32
USING THE BUILT-IN FLASH
BASIC OPERATION
Changing the Flash Mode
Flash Range
•Do not use the built-in flash with with lenses with focal lengths shorter than
28mm.
• Make sure you are at least 1m (3.3 ft.) from your subject when using the
built-in flash.
The subject must be within the flash range specified in the table
below for the image to be properly exposed.
• Except when flash cancel is selected, the built-in-flash will pop-up
automatically when the shutter-release button is pressed partway down.
Once the flash is up, it will fire when necessary.
•The shutter will not release until the flash is charged.
•Push down the built-in flash when the camera is not in use.
• When the camera is turned off, the flash mode is reset to autoflash or
autoflash with red-eye reduction whichever was set last. See p. 36.
When the flash mode button is pressed, the flash mode changes in
the following sequence:
Autoflash
Autoflash with red-eye reduction
Fill flash
Fill flash with red-eye reduction
Flash cancel
28-80mm F3.5-5.6 (D) 35-80mm F4-5.6 II
Wide angle Wide angle Telephoto
1.0 ~ 3.4 m
(3.3 ~ 11.2 ft.)
1.0 ~ 4.0 m
(3.3 ~ 13.1 ft.)
1.0 ~ 4.0 m
(3.3 ~13.1 ft.)
1.0 ~ 2.1 m
(3.3 ~ 6.9 ft)
1.0 ~ 3.0 m
(3.3 ~ 9.8 ft.)
1.0 ~ 2.1 m
(3.3 ~ 6.9 ft.)
1.0 ~ 4.0 m
(3.3 ~13.1 ft.)
1.0 ~ 4.0 m
(3.3 ~13.1 ft.)
TelephotoFilm Speed
ISO 100
ISO 400
LENS IN USE
To Next Page
Loading...
