Minolta DYNAX 7 - BASIC OPERATION

(2181) 9
REPAIR GUIDE
+
−−
−−
−
■■
■■
■
Fig. 4Fig. 4
Fig. 4Fig. 4
Fig. 4
SHUTTER CHARGE GEARSHUTTER CHARGE GEAR
SHUTTER CHARGE GEARSHUTTER CHARGE GEAR
SHUTTER CHARGE GEAR
SHUTTER SPACERSHUTTER SPACER
SHUTTER SPACERSHUTTER SPACER
SHUTTER SPACER
■■
■■
■
Fig. 5 SHUTTER ASSY InstallationFig. 5 SHUTTER ASSY Installation
Fig. 5 SHUTTER ASSY InstallationFig. 5 SHUTTER ASSY Installation
Fig. 5 SHUTTER ASSY Installation
1. Supply power to the charg motor at 2V/1A to drive it normally until the mirror raises1. Supply power to the charg motor at 2V/1A to drive it normally until the mirror raises
1. Supply power to the charg motor at 2V/1A to drive it normally until the mirror raises1. Supply power to the charg motor at 2V/1A to drive it normally until the mirror raises
1. Supply power to the charg motor at 2V/1A to drive it normally until the mirror raises
completely.completely.
completely.completely.
completely.
DC Power SupplyDC Power Supply
DC Power SupplyDC Power Supply
DC Power Supply
(2V/1A)(2V/1A)
(2V/1A)(2V/1A)
(2V/1A)
DriverDriver
DriverDriver
Driver
2. Insert screw driver into the hole of "SHUTTER CHARGE GEAR", and put "SHUTTER2. Insert screw driver into the hole of "SHUTTER CHARGE GEAR", and put "SHUTTER
2. Insert screw driver into the hole of "SHUTTER CHARGE GEAR", and put "SHUTTER2. Insert screw driver into the hole of "SHUTTER CHARGE GEAR", and put "SHUTTER
2. Insert screw driver into the hole of "SHUTTER CHARGE GEAR", and put "SHUTTER
ASSY" by holding the screw driver at the 90 degrees position shown on the picture.ASSY" by holding the screw driver at the 90 degrees position shown on the picture.
ASSY" by holding the screw driver at the 90 degrees position shown on the picture.ASSY" by holding the screw driver at the 90 degrees position shown on the picture.
ASSY" by holding the screw driver at the 90 degrees position shown on the picture.