Mirion Technologies RDS-32 - Maximum Dose Rate Record

RDS-32 FUNCTIONALITY
14
To reset the accumulated dose, navigate to DOSE in the menu, press the Select key once so
that the RESET function starts to blink. Press the Select key a second time to see the
confirmation phase SURE? Then press the Select key a second time to perform the reset.
Cancel the dose reset process by pressing the left arrow key.
3.3 MAXIMUM DOSE RATE RECORD
The meter monitors maximum dose rate while measuring. The maximum recorded dose rate
can be viewed by entering the menu.
To reset the maximum recorded dose rate, navigate to MaxDR in the menu, press the Select
key once so that the RESET function starts to blink. Press the Select key a second time to
see the confirmation phase SURE? Then press the Select key a second time to perform the
reset.
Use the DOSE key to quickly check accumulated dose from the Main display. Press the
key a second time to see time remaining until dose alarm.
The RDS-32 collects dose continuously while switched on and saves that value in the
meter memory even if the meter is switched off/on. To follow accumulated dose by task
or mission, reset the dose as indicated above. Alternatively, set a suitable histogram data
save period so that the dose accumulation can be discerned from the histogram data.
See Chapter 3.9 Histogram for more details. Note that the CSW-32 configuration
software is required to access the histogram data.