GETTING STARTED
5
2.3 POWER ON
POWER ON the device by pressing the Select key for two seconds.
The firmware version, time and calibration status are first shown on the display. If the time of
meter’s Real Time Clock is not set, the flashing ‘TIME NOT SET’ message is displayed. If
necessary, the Real Time Clock can be reset with the CSW-32 Configuration Software.
When switched on the meter performs the following self-test functions:
• All the display pixels are turned on
• The buzzer is activated
• The vibration is activated
• The display backlight is switched on
• The battery condition is tested
• The HV-generator is tested
After the initialization phase is complete, the Main display with dose rate will be shown.
2.4 POWER OFF
POWER OFF the device by first pressing the Select key so that the OFF selection is activated.
Press the Select key again and hold for four seconds while the counter counts down.
If the select key is released before the countdown is complete, and the device powers off,
the device will return to the menu display.
To Next Page
Loading...
