GETTING STARTED
4
Detector positions for GM-tube or both detectors, depending on the meter version, are
illustrated in the picture below. The detector positions are also indicated with markings on
the meter itself. The triangles on the meter sides indicate the reference line and the dot on
the back of the meter indicates the GM-tube center point. On the WR models there is an
additional dot to indicate the center point of the Si diode.
2.2 INSERTING BATTERIES
The instrument uses two IEC (LR6/ HR6) AA-size batteries. The use of alkaline batteries is
recommended, but rechargeable NiMH batteries can also be used. When using NiMH
batteries, the CSW-32 Configuration software is required to select the correct battery type.
Open the battery compartment using a Pozidriv #1 screwdriver. Observe the correct polarity
of the batteries.
RDS-32 is delivered with two battery covers. One of the covers has belt clip attached to it.
To Next Page
Loading...
