RDS-32 FUNCTIONALITY
25
3.8 COMMUNICATION
3.8.1 WRM
The WRM functionality is used to send data packets via radio system or an external data
connection, for example serial line or Local Area Network. The WRM can be set to OFF or to
send messages in intervals between two seconds to one hour.
In RDS-32iTx versions an internal radio modem enables the dose/dose rate data transmission
to any WRM compatible system.To activate the WRM communication in an RDS-32iTx
version (or set data send interval in RS communication or over Local Area Network):
Navigate into the WRM menu and select a suitable send interval from the available options: 2
s, 4 s, 10 s, 20 s, 30 s, 60 s, 5 min, 10 min, 15 min, 30 min and 60 min.
Change the state to OFF to deactivate the WRM communication.
If the WRM is activated the Main display will show the symbol .See the software manual
for the additional settings available for serial or LAN communication.
To Next Page
Loading...
