Mitel IP 5330 User Manual

19
Mitel Networks
5330 IP Phone
Auto-Answer
When the Auto-Answer feature is active, incoming calls ring briefly, and then
the phone answers the call in Handsfree mode. You can continue the call
handsfree or use the handset.
To enable or disable Auto-Answer:
 Press Auto-Answer key. (See Programming Features on Your Keys for
instructions on programming features on your phone.) The key is
highlighted and all incoming calls are answered in Handsfree mode.
To switch from Handsfree mode to handset mode:
1. Lift the handset
To end a call, do one of the following:
 Press (Cancel)
 Press the Hang Up softkey.
 Wait for the caller to hang up.
Using the Analog line
The phone can support the Line Interface Module. See Using the Line Interface
Module for more information.
CALL HANDLING
Hold
To place a call on Hold:
 Press (HOLD).
 Press the key that you have programmed as Hold. The indicator flashes on
the line that has the held call.
Note: You can only retrieve a call from hold when the phone is idle.
To retrieve a call from Hold, do one of the following:
 Lift the handset and press the flashing line.
 Press the flashing indicator.
 Use the Add Held feature to conference into the held call.
To retrieve a call from Hold at another phone, do one of the following:
 Press the flashing line key.
 Dial the appropriate feature access code and the number of the station that
placed the call on Hold.

Mitel IP 5330 Specifications

General

Protocols	MiNet and SIP
Headset Port	Dedicated headset port
Fixed Function Keys	Hold, Transfer, Conference, Volume, Mute
Audio	Full-duplex speakerphone
Network Ports	2 x 10/100 Mbps Ethernet ports
Power	Power over Ethernet (PoE)
Weight	2.2 lbs
Dimensions	8.5 x 7.5 x 6.5 inches (216 x 191 x 165 mm)