Mitel IP 5330 - Using the Line Interface Module; Analog Line Call Handling

36
Mitel Networks
5330 IP Phone
USING THE LINE INTERFACE MODULE
Your phone supports the Mitel Line Interface Module. The Line Interface
Module allows you to make and receive calls over an analog line (Line Interface
Module line) connected to your phone. The Line Interface Module operates in
either of the following two modes, as determined by your System Administrator:
 Line Interface Module Mode: your phone allows you to use the Line
Interface Module line at any time
 Failover Mode: you can use the Line Interface Module line only when
the IP connection has failed
Note: Handsfree and on-hook dialing are not supported on the Line Interface
Module line.
For information on emergency number dialing using the Line Interface Module,
refer to Emergency Calls.
Making and Answering Calls Using the Analog key
To make a call using the Analog line:
1. Lift the handset.
2. Press the key you programmed as Analog Line.
ANALOG CALL is displayed.
3. Dial the number.
Note: When you make an external call over the analog line, a prefix dialing
number is not required. If your phones Analog Line key has the Privacy option
enabled, you cannot access the analog line when another phone is using the
analog line (key is solid orange). To access the analog line, the user of the
other phone must first hang up. To determine whether the Privacy option is
enabled, contact your System Administrator.
To answer a Call using the analog line:
1. Lift the handset.
2. Press the Analog Line key that is highlighted.
To answer a waiting call on the analog line:
Note: If you have subscribed to an analog call waiting service, you may use the
hookswitch or press Cancel ( ) to answer a waiting analog call. When you
are on an analog call and a waiting analog call arrives, you hear a beep. This
feature may not be supported in all regions.