Mitsubishi Electric MELSEC-A/QnA Series User Manual

4 TEMPERATURE INPUT MODULE REPLACEMENT
4 - 19
4.3.3 I/O signal comparison to programmable controller CPU
Sequence program change is required as the I/O signals differ.
For details of the I/O signals and sequence program, refer to the Thermocouple Input Module/Channel
Isolated Thermocouple/Micro Voltage Input Module User's Manual.
A616TD Q68TD-G-H02, Q68TD-G-H01
Device
No.
Signal name
Device
No.
Signal name
Device
No.
Signal name
Device
No.
Signal name
X0 Watchdog timer error Y0
Not used
X0 Module READY Y0
Not used
X1 A/D conversion READY Y1 X1
Not used
Y1
X2 Error flag Y2 X2 Y2
X3
Disconnection error
detection
Y3 X3 Y3
X4
Digital output value out-
of-range detection
Y4 X4 Y4
X5
Detected temperature
value out-of-range
detection
Y5 X5 Y5
X6
Not used
Y6 X6 Y6
X7 Y7 X7 Y7
X8 Y8 X8 Y8
X9 Y9 X9
Operating condition
setting completion flag
Y9
Operating condition
setting request
XA YA XA
Offset/gain setting mode
status flag
YA User range write request
XB YB XB
Channel change
completion flag
YB Channel change request
XC YC XC
Q68TD-G-H02:
Disconnection detection
signal
Q68TD-G-H01:
Disconnection status
monitor signal
YC
Not used
XD YD Interlock signal for the
RFRP and RTOP
instructions when the
A616TD is used in
remote I/O station
XD Warning output signal YD
XE YE XE
Conversion completion
flag
YE
XF YF XF Error flag YF Error clear request
X10 Y10
Detected temperature
value LED display
request signal
X11 Y11
Not used
X12 Y12
X13 Y13
X14 Y14
X15 Y15
X16 Y16
X17 Y17
X18 Y18
X19 Y19
X1A Y1A
X1B Y1B
X1C Y1C
X1D Interlock signal for the
RFRP and RTOP
instructions when the
A616TD is used in
remote I/O station
Y1D
X1E Y1E
X1F Y1F

Mitsubishi Electric MELSEC-A/QnA Series Specifications

General

Brand	Mitsubishi Electric
Model	MELSEC-A/QnA Series
Category	Controller
Language	English