Mitsubishi Electric MELSEC-A/QnA Series - Page 193

4 TEMPERATURE INPUT MODULE REPLACEMENT
4 - 50
Q68RD3-G
Address
(decimal)
Name Read/write
40 CH7 Offset temperature setting value
R/W
41 CH7 Gain temperature setting value
42 CH8 Offset temperature setting value
43 CH8 Gain temperature setting value
44 to 45 System area (Not used) -
46 Warning output enable/disable setting R/W
47 Warning output flag (Process alarm)
R
48 Warning output flag (Rate alarm)
49 Disconnection detection flag
50 to 57 CH1 to CH8 Scaling value
58 Scaling valid/invalid setting R/W
59 to 61 System area (Not used) -
62 CH1 Scaling range lower limit value
R/W
63 CH1 Scaling range upper limit value
to
77 CH8 Scaling range upper limit value
R/W
78 CH1 Scaling width lower limit value
79 CH1 Scaling width upper limit value
to
93 CH8 Scaling width upper limit value
R/W
94 CH1 Process alarm lower/lower limit value
95 CH1 Process alarm lower/upper limit value
96 CH1 Process alarm upper/lower limit value
97 CH1 Process alarm upper/upper limit value
to
125 CH8 Process alarm upper/upper limit value
R/W
126 to 133
CH1 to CH8 Rate alarm warning detection
period
134 CH1 Rate alarm upper limit value
135 CH1 Rate alarm lower limit value
to
149 CH8 Rate alarm lower limit value R/W
150 to 157 System area (Not used) -
158 to 159 Mode switching setting R/W
160 to 163 System area (Not used) -
164
Conversion setting for disconnection
detection (CH1-CH4)
R/W
165
Conversion setting for disconnection
detection (CH5-CH8)
166 to173
CH1 to CH8 Conversion setting value for
disconnection detection
174 to 189 System area -
190 CH1 Factory default offset value
R/W
191 CH1 Factory default gain value
192 CH1 User range settings offset value
193 CH1 User range settings gain value
194 CH1 User range settings offset (L)
resistance value (H)
195
196 CH1 User range settings gain (L)
resistance value (H)
197
to
253
CH8 User range settings gain resistance
value (H)
R/W