5 - 43
Chapter 5 Data Used for Positioning Control
[Pr.40] Positioning complete signal output time
Set the output time of the positioning complete signal output from the Simple
Motion module.
A positioning completes when the specified dwell time has passed after the Simple
Motion module had terminated the command output.
For the interpolation control, the positioning completed signal of interpolation axis
is output only during the time set to the reference axis.
M
QD77GF
[Y10 to Y1F]
PLC CPU
Positioning
start signal
Positioning
complete signal
Positioning
Positioning complete signal
(after dwell time has passed)
Output time
Positioning start signal
Start complete signal
BUSY signal
Positioning complete signal
( Status: b15)
Md.31
Positioning complete signal output time
To Next Page
Loading...
