1 - 24
Chapter 1 Product Outline
1.2.2 Outline of starting
The outline for starting each control is shown with the following flowchart.
(It is assumed that each module is installed, and the required system configuration,
etc., has been prepared.)
Flow of starting
Preparation
Major positioning
control
Control
functions
Installation and connection of module
Setting of hardware
Positioning
data
Block start
data
Positioning
parameters
HPR
parameters
Servo
parameters
PLC READY
All axis
servo ON
Expansion
parameters
Start signal
Control start
Control end
Control data
High-level positioning
control
HPR control
Manual control
Position control
Speed control
Speed-position
switching control
Position-speed
switching control
Other control
Block start (Normal start)
Condition start
Wait start
Simultaneous start
Repeated start
Machine HPR control
Fast HPR control
JOG operation
Inching operation
Manual pulse generator
operation
Turn the All axis servo ON signal ON (Y1 ON)
Turn the PLC READY signal ON (Y0 ON)
Set the servo parameters.
Set the expansion parameters. ( , , ) Pr.113
Pr.132Pr.96
( to , to )
Da.1
Da.10 Da.20 Da.22
Set the positioning data.
Set the block start data.
( to , to )Da.11
Da.19 Da.23 Da.26
Operation
Stop
Operate the
manual pulse
generator
Turn the QD77GF JOG
start signal ON from the
PLC CPU
Input the start signal.
Method (1) Turn ON the QD77GF start signal from the PLC CPU
Method (2) Turn the QD77GF external command signal ON
Cd.3
Set the positioning start No. ( )
(
)
Cd.4
Set the positioning starting point No.
Set the manual pulse generator
1 pulse input magnification.
(
)Cd.20
Set the positioning parameters. ( to , to , , , ) Pr.1 Pr.42 Pr.84Pr.80 Pr.89 Pr.90 Pr.95
Set the HPR parameters.
( to )
Pr.43
Pr.57
(
)Cd.17
Set the JOG speed.
Set "0" to the inching
movement amount.
(
)
Cd.16
Set a value except "0" to the
inching movement amount.
(
)
Cd.16
Set "1" to the manual pulse
generator enable flag.
(
)Cd.21
To Next Page
Loading...
