12 - 18
Chapter 12 Expansion Control
12.2 Synchronous control
"Synchronous control" can be achieved using software instead of controlling
mechanically with gear, shaft, speed change gear or cam, etc.
"Synchronous control" synchronizes movement with the input axis (servo input axis or
synchronous encoder axis), by setting "the parameters for synchronous control" and
starting synchronous control on each output axis.
Refer to "MELSEC-Q/L QD77MS/QD77GF/LD77MS/LD77MH Simple Motion Module
User's Manual (Synchronous Control)" for details of synchronous control.
To Next Page
Loading...
