Mitsubishi Electric MELSEC-Q Series - Buffer Memory Area Configuration

7 - 5
Chapter 7 Memory Configuration and Data Process
7.1.2 Buffer memory area configuration
The buffer memory of Simple Motion module is configured of the following types of
areas.
Buffer memory area configuration
Buffer memory address
*1
Writing
possibility
Parameter area
Basic parameter 0+150n to 15+150n
Possible
Detailed parameter 17+150n to 69+150n
HPR basic parameter 70+150n to 78+150n
HPR detailed parameter 80+150n to 89+150n
Expansion parameter 100+150n to 149+150n
Mark detection setting parameter 54000+20k to 54019+20k
Monitor data area
System monitor
4000 to 4299
31300 to 31549
Not possible
Axis monitor 2400+100n to 2499+100n
Mark detection monitor data 54960+80k to 55039+80k
Control data area
System control data 5900 to 5999
Possible
Axis control data
4300+100n to 4399+100n
30100+10n to 30109+10n
Mark detection control data 54640+10k to 54649+10k
Positioning data area
(No.1 to 100)
Positioning data
6000+1000n to 6999+1000n
Positioning data area
(No.101 to 600)
Set with GX Works2
Block start data area
(No.7000)
Block start data
22000+400n to 22049+400n
22050+400n to 22099+400n
Condition data 22100+400n to 22199+400n
Block start data area
(No.7001)
Block start data
22200+400n to 22249+400n
22250+400n to 22299+400n
Condition data 22300+400n to 22399+400n
Block start data area
(No.7002)
Block start data
Set with GX Works2
Condition data
Block start data area
(No.7003)
Block start data
Condition data
Block start data area
(No.7004)
Block start data
Condition data