Mitsubishi Electric MELSEC-Q Series - Page 195

5 - 75
Chapter 5 Data Used for Positioning Control
When "[Pr.1] Unit setting" is "mm"
The table below lists the control methods that require the setting of the arc
address and shows the setting range.
(With any control method excluded from the table below, the arc address does not
need to be set.)
[Da.2] setting value
Value set with GX Works2
(

m)
Value set with sequence program 1
(

10
-1

m)
ABS circular sub : 0DH
ABS circular right : 0FH
ABS circular left : 10H

Set the address
-214748364.8 to 214748364.7
2

Set the address
-2147483648 to 2147483647
INC circular sub : 0EH
INC circular right : 11H
INC circular left : 12H

Set the movement amount
-214748364.8 to 214748364.7 2

Set the movement amount
-2147483648 to 2147483647 2
1: Set an integer because the sequence program cannot handle fractions.
(The value will be converted properly within the system.)
2
: Note that the maximum radius that circular interpolation control is possible is 536870912 (

10
-1

m), although the
setting value can be input within the range shown in the above table, as an arc address.
When "[Pr.1] Unit setting" is "degree"
No control method requires the setting of the arc address by "degree".
When "[Pr.1] Unit setting" is "PLS"
The table below lists the control methods that require the setting of the arc
address and shows the setting range.
(With any control method excluded from the table below, the arc address does not
need to be set.)
[Da.2] setting value
Value set with GX Works2
(PLS)
Value set with sequence program
1
(PLS)
ABS circular sub : 0DH
ABS circular right : 0FH
ABS circular left : 10H

Set the address
-2147483648 to 2147483647 1

Set the address
-2147483648 to 2147483647
INC circular sub : 0EH
INC circular right : 11H
INC circular left : 12H

Set the movement amount
-2147483648 to 2147483647 1

Set the movement amount
-2147483648 to 2147483647 1
1: Note that the maximum radius that circular interpolation control is possible is 536870912 (PLS), although the setting
value can be input within the range shown in the above table, as an arc address.