Mitsubishi Electric MELSEC-Q Series - Page 257

5 - 137
Chapter 5 Data Used for Positioning Control
Setting value
Default
value
Buffer memory address
Set with a decimal.
K
1
M code OFF request
Setting value
After the M code ON signal turns OFF, "0" is stored by the Simple Motion
module automatically. (Indicates that the OFF request is completed.)
1: M code ON signal turns OFF
0 4304+100n
Set with a decimal.
Setting value
External command valid
0: Invalidates an external command.
1: Validates an external command.
K
0 4305+100n
Set with a decimal.
A
ctual value
Conversion into an integer value
Cd.9 New current value
10
m
Unit conversion table ( Cd.9 )
m
1
5
5
0
inch
degree
PLS
Unit
R
Setting value
(Decimal)
m
0
4306+100n
4307+100n
Set with a decimal.
Cd.10 New acceleration time value
Cd.11 New deceleration time value
Setting
value
Example: When the " Cd. 10 New acceleration
time value" is set as "60000 ms", the
buffer memory stores "60000".
0
4308+100n
4309+100n
0
4310+100n
4311+100n
n: Axis No.-1