Mitsubishi Electric MELSEC-Q Series - Page 269

5 - 149
Chapter 5 Data Used for Positioning Control
Setting value
Default
value
Buffer memory address
Set with a decimal.
Setting
value
K
Cd.30
Simultaneous starting own
axis start data No.
Cd.31
Cd.33
to
Simultaneous starting axis
start data No.
1 to 600
0 4340+100n
0 4341+100n
0 4342+100n
0 4343+100n
Set with a decimal.
Setting
value
Step mode
0: Stepping by deceleration units
1: Stepping by data No. units
K
0 4344+100n
Set with a decimal.
Setting
value
Step valid flag
0: Invalidates step operations
1: Validates step operations
K
0 4345+100n
Set with a decimal.
Setting
value
Step start information
1: Continues step operation
K
The Simple Motion module resets the value to "0" automatically
when processing of the step start request completes.
0 4346+100n
n: Axis No.-1