Mitsubishi Electric MELSEC-Q Series - Page 345

6 - 63
Chapter 6 Sequence Program Used for Positioning Control
(5) Time chart for starting "position-speed switching control"
Positioning start signal
V
t
Operation pattern (00)
Positioning data No. (1)
Position control Speed control
[Y10]
PLC READY signal
READY signal
Start complete signal
BUSY signal
Positioning complete signal
Error detection signal
0
1
Cd. 3 Positioning start No.
Cd. 26 Position-speed
switching enable flag
1
[Y0]
[X0]
[X10]
Stop command
Position-speed switching signal
All axis servo ON
[Y1]
StandbyServo OFF
Md. 26 Axis operation status
( Md. 31 Status: b14)
( Md. 31 Status: b15)
( Md. 31 Status: b13)
Fig. 6.8 Time chart for starting "position-speed switching control"