Mitsubishi Electric MELSEC-Q Series - Page 495

9 - 95
Chapter 9 Major Positioning Control
(2) The following table shows the items that must be set to use the proximity dog
signal (DOG) as speed-position switching signals.
Setting item
Setting
value
Setting details Buffer memory address
[Cd.45]
Speed-position
switching device
selection
1
Use the proximity dog signal
for switching from speed
control to position control
4366+100n
(Note): The setting is not required for "[Pr.42] External command function selection" and "[Cd.8] External
command valid".
Refer to Section 5.7 "List of control data" for information on the setting details.
(3) The following table shows the items that must be set to use "[Cd.46] Speed-
position switching command" as speed-position switching signals.
Setting item
Setting
value
Setting details Buffer memory address
[Cd.45]
Speed-position
switching device
selection
2
Use the "[Cd.46] Speed-
position switching command"
for switching from speed
control to position control
4366+100n
(Note): The setting is not required for "[Pr.42] External command function selection" and "[Cd.8] External
command valid".
Refer to Section 5.7 "List of control data" for information on the setting details.