16 - 4
Chapter 16 Troubleshooting
2) Error code (D000H to DFFFH)
Item Description
Communication status (own station) The communication status of own station (at error occurrence) is stored.
Cause of communication interruption The cause of communication interruption is stored.
Cause of data link stop The cause of data link stop is stored.
Connection status (own station) The connection status of own station (at error occurrence) is stored.
Baton pass status (each station)
(station No.1 to 16)
The baton pass status of station No.1 to 16 (at error occurrence) is stored (in binary).
Baton pass status (each station)
(station No.17 to 32)
The baton pass status of station No.17 to 32 (at error occurrence) is stored (in binary).
Baton pass status (each station)
(station No.33 to 48)
The baton pass status of station No.33 to 48 (at error occurrence) is stored (in binary).
Baton pass status (each station)
(station No.49 to 64)
The baton pass status of station No.49 to 64 (at error occurrence) is stored (in binary).
Baton pass status (each station)
(station No.65 to 80)
The baton pass status of station No.65 to 80 (at error occurrence) is stored (in binary).
Baton pass status (each station)
(station No.81 to 96)
The baton pass status of station No.81 to 96 (at error occurrence) is stored (in binary).
Baton pass status (each station)
(station No.97 to 112)
The baton pass status of station No.97 to 112 (at error occurrence) is stored (in
binary).
Baton pass status (each station)
(station No.113 to 120)
The baton pass status of station No.113 to 120 (at error occurrence) is stored (in
binary).
Dedicated instruction name in which the error
occurred
The name of dedicated instruction in which the error occurred is stored.
Dedicated instruction CH in which the error
occurred
The CH No. of dedicated instruction in which the error occurred is stored.
Target network No. in which the error occurred The target network No. in which the error occurred is stored.
Target station No. in which the error occurred The target station No. in which the error occurred is stored.
(c) [Create CSV File] button
The module error logs are output to a CSV format file.
POINT
(1) If errors frequently occur in the Simple Motion module, "*HST.LOSS*" (instead
of an actual error code) may be displayed in the Error Code column.
(Display example)
If "*HST.LOSS*" is frequently displayed, set a larger value for the number of
errors collected per scan in the PLC RAS tab of the PLC Parameter dialog
box.
For the setting, refer to the "User's Manual (Function Explanation, Program
Fundamentals)" of the CPU module in use.
(2) If the error occurred at the simultaneous start, the axis No. in which the error is
detected is stored in the "Starting axis" in Error History.
To Next Page
Loading...
