16 - 35
Chapter 16 Troubleshooting
Related buffer memory address
Set range
(Setting with sequence program)
Remedy
24+150n
25+150n
1 to 2147483647
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
26+150n 1 to 1000
27+150n 0, 1
28+150n 0, 1
29+150n 0, 1
30+150n 0, 1, 2
33 0, 1, 2, 3
34+150n 0, 2
• Speed-position switching control (ABS mode) should satisfy
the conditions 1) to 3) given on the left.
• When speed-position switching control (ABS mode) is not to
be exercised, set 0 to speed-position function selection and
turn the PLC READY signal [Y0] from OFF to ON.
32+150n 0, 1, 2, 3, 4, 5, 6
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
35 0, 1
31+150n 0, 1
With the setting of the axis is matched, turn the PLC READY
signal [Y0] from OFF to ON.
36+150n
37+150n
1 to 8388608
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
38+150n
39+150n
1 to 8388608
40+150n
41+150n
1 to 8388608
n: Axis No.-1
To Next Page
Loading...
