Mitsubishi Electric MELSEC-Q Series - Page 804

Appendix - 4
Appendices
Buffer memory address Item
Memory
area
70+150n
[Pr.43] HPR method
HPR basic parameters
HPR parameters
71+150n
[Pr.44] HPR direction
72+150n
73+150n
[Pr.45] HP address
74+150n
75+150n
[Pr.46] HPR speed
76+150n
77+150n
[Pr.47] Creep speed
78+150n
[Pr.48] HPR retry
80+150n
81+150n
[Pr.50] Setting for the movement amount after proximity dog
ON
HPR detailed parameters
82+150n
[Pr.51] HPR acceleration time selection
83+150n
[Pr.52] HPR deceleration time selection
84+150n
85+150n
[Pr.53] HP shift amount
86+150n
[Pr.54] HPR torque limit value
87+150n
[Pr.55] Operation setting for incompletion of HPR
88+150n
[Pr.56] Speed designation during HP shift
89+150n
[Pr.57] Dwell time during HPR retry
105
[Pr.96] Operation cycle setting
Expansion
parameter
113+150n
[Pr.113] Servo parameter transfer
132+150n
[Pr.132] Communication mode setting
n: Axis No.-1