Mitsubishi Electric MELSEC-Q Series - Page 81

3 - 13
Chapter 3 Specifications and Functions
Functions that limit control Functions that change control details Other functions
Speed limit function Torque limit function Software stroke limit function Hardware stroke limit function Forced stop function Speed change function Override function
A
cceleration/ deceleration time change
function Torque change function Target position change function Step function Skip function M code output function Teaching function Command in-position function
A
cceleration/deceleration processing
function Pre-reading start function Deceleration start flag function Stop command processing for deceleration stop function Speed control 10 x multiplier setting for degree axis function Operation setting for incompletion of HPR function
*
3
*
3
*
3
*
4
*
6
*
6
*
7
*
8
*
10
*
5
*5 *5
*
5
*
9
*
12
*
14
*
14
: Always combine, : Combination possible, : Combination limited, : Combination not possible
13: It is available only in MR-J4-B-RJ010 communication mode.
14: Refer to "MELSEC-Q/L QD77MS/QD77GF/LD77MS/LD77MH Simple Motion Module User's Manual (Synchronous Control)" for details.