How to resolve Scaling setting out-of-range on Mitsubishi Electric NZ2EX2B-60AD4?
To fix a 'Scaling setting out-of-range' error on your Mitsubishi Electric Controller, set a value within the range of -32000 to 32000 in CH1 Scaling lower limit value (address: 0121H) to CH4 Scaling upper limit value (address: 0128H).
What to do if Disconnection detection setting error occurs on Mitsubishi Electric NZ2EX2B-60AD4?
To resolve a 'Disconnection detection setting error' on your Mitsubishi Electric Controller: * Set the input range of the channel that detects disconnection within the range of 4 to 20mA or 1 to 5V. * Alternatively, set Input signal error detection setting (address: 0109H) of the corresponding channel to a value other than Disconnection detection (4H).
How to resolve Input signal error detection setting out-of-range on Mitsubishi Electric NZ2EX2B-60AD4 Controller?
To correct an 'Input signal error detection setting out-of-range' error on your Mitsubishi Electric Controller, set the value in the channel where an error has occurred in Input signal error detection setting (address: 0109H) to either Disable (0H) or Disconnection detection (4H).
What to do if Mitsubishi Electric NZ2EX2B-60AD4 shows non-volatile memory data error (parameter)?
If your Mitsubishi Electric Controller displays a non-volatile memory data error related to parameters, follow these steps: * Set no request (0), request (1), and no request (0) in Parameter information clear request (address: 1002H) to set the parameters of the non-volatile memory to default. * Set the parameters again. * Use a shielded cable for connection to protect against noise. If the issue remains, it may indicate a module failure, and you should consult your local Mitsubishi representative.
How to resolve Conversion speed setting out-of-range on Mitsubishi Electric NZ2EX2B-60AD4 Controller?
To correct a 'Conversion speed setting out-of-range' error on your Mitsubishi Electric Controller, set the Conversion speed setting (address: 0001H) to one of the following values: 400µs/channel (0H), 1ms/channel (1H), or 100µs/channel (2H).
How to resolve Moving average setting out-of-range on Mitsubishi Electric NZ2EX2B-60AD4 Controller?
To correct a 'Moving average setting out-of-range' error on your Mitsubishi Electric Controller, set the moving average count to a value within the range of 2 to 128.
How to resolve Count average setting out-of-range on Mitsubishi Electric Controller?
To fix a 'Count average setting out-of-range' error on your Mitsubishi Electric Controller, set the averaging count to a value in the range of 4 to 65000.
How to fix Averaging time setting out-of-range error on Mitsubishi Electric Controller?
To resolve an 'Averaging time setting out-of-range' error on your Mitsubishi Electric Controller, set the averaging time to a value within the range of 2 to 5000ms.
How to resolve Same address for the external signal assignment function on Mitsubishi Electric Controller?
To resolve the issue of the same address being set for the external signal assignment function on your Mitsubishi Electric Controller, ensure that you set a unique address for each extension output module.
How to fix External signal assignment setting error on Mitsubishi Electric NZ2EX2B-60AD4?
To resolve an external signal assignment setting error in your Mitsubishi Electric Controller, adjust the external signal assignment function to fall within the addresses assigned to the extension I/O module.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | NZ2EX2B-60AD4 |
| Category | Controller |
| Language | English |
To Next Page