3 Controller
Pneumatic hand interface
3-62
■ Installation method
This is mounted in the controller.
Attach the pneumatic hand interface (2A-RZ365/2A-RZ375) to the CNHNDOUT/CNHND connector of the hand
interface relay card (2D-TZ315) securely. Refer to separate "Instruction Manual/ Controller setup, basic
operation, and maintenance" for details on the installing method.
Fig.3-20 ： Installation of the pneumatic hand interface
CNHNDOUT
CNHND
Pneumatic hand interface
CNHND
CNHNDOUT
Pneumatic hand interface
（2A-RZ365）
Hand interface relay card
（2D-TZ315）
M4x2
Hand interface relay card
(2A-RZ365/2A-RZ375)
*The connector of machine cable con
-
nection has some from which form
differs.
To Next Page
Loading...
