4G1 ENGINE (E-W) -
Crankshaft and Cylinder Block
11A-12-7
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"
C
A
BEARING CAP INSTALLATION
(1) On the bottom surface of each bearing cap is the cap’s
number and an arrow. Starting at th e timing belt side,
fit the bearing caps in numerical order. Ensure that the
arrows point toward the timing belt side.
(2) After fitting the bearing caps, measure t h e end play in
the crankshaft. If the measurement exceeds the specified
limit, replace the crankshaft bearings.
Standard value: 0.05 - 0.18 mm
Limit: 0.25 mm
"
D
A
REAR OIL SEAL INSTALLATION
(1) Press-fit t he rear oil seal using th e special tool shown
in the illustration.
PWEE9520-A
E
Dec. 1998Mitsubishi Motors Corporation Added
Arrow indicating front
of engine
Cap No.
3EN0174
Oil seal
Oil seal case
MD998011
To Next Page
Loading...
Need help?
General
