4G9 ENGINE (E-W) -
Timing Belt
11A-4-6
PWEE9502-A
E
Nov. 1995Mitsubishi Motors Corporation Revised
"
F
A
TIMING BELT INSTALLATION
(1) Make sure that the auto-tensioner is installed properly.
(Refer to service point F.)
(2) Align the timing mark on each sprocket with the
corresponding mark on the timing belt.
(3) Turn the crankshaft sprocket one half the tooth width
counterclockwise.
(4) Fit the timing belt to the intake camshaft sprocket and
secure with a paper clip at the illustrated position.
(5) Use two wrenches to fit the timing belt to the exhaust
sprocket while aligning t he timing marks.
Timing marks
Timing mark
Paper clip
Timing mark
Timing mark
To Next Page
Loading...
