4G9 ENGINE (E-W) -
Intake and Exhaust Manifold <4G94- GDI for PAJERO io>
11A-6d-2
INSTALLATION SERVICE POINTS
"
A
A
EXHAUST MANIFOLD BRACKET INSTALLATION
(1) The washers must be installed with the shear-drooped
side toward the bolts.
(2) Temporarily install the exhaust manifold bracket as shown
in the illustration.
(3) Verify that the bracket is brought into close contact with
the boss on the exhaust manifold, then tighten the bolts
to the specified torque.
"
B
A
INTAKE MANIFOLD STAY INSTALLATION
(1) Check to ensure that the intake manifold stay is in close
contact with the intake manifold and the cylinder block
before tightening the respective mounting bolts to the
specified torque.
PWEE9502-H
E
July 2000Mitsubishi Motors Corporation Added
Shear-droop
Exhaust
manifold
Bracket
Intake
manifold
Cylinder block
Intake
manifold
stay
To Next Page
Loading...
