Mitsubishi 4G9 - Engine Coolant Temperature Gauge Unit Installation; Engine Coolant Temperature Sensor Installation; Water By-Pass Fitting Installation

4G9 ENGINE (E–W) – Water Pump and Water Hose
11A-7-6
PWEE9502
E
May 1995Mitsubishi Motors Corporation
"FA ENGINE COOLANT TEMPERATURE GAUGE UNIT
INSTALLATION
(1) Apply the specified sealant to the threads.
Specified sealant:
3M ATD Part No.8660 or equivalent
"GA ENGINE COOLANT TEMPERATURE SENSOR
INSTALLATION
(1) When reusing the sensor, apply the specified sealant
to the threads.
Specified sealant:
3M Nut Locking Part No.4171 or equivalent
"HA WATER BY-PASS FITTING INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent.
"IA WATER FITTING INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent.
PWEE9502-K
E
Jun. 2002Mitsubishi Motors Corporation Added
<REAR WHEEL DRIVE>