EasyManuals Logo

Mitsubishi FREQROL-SF User Manual

Mitsubishi FREQROL-SF
219 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
1 Troubleshooting
1.1 Status display
and diagnosis
(d)
External signal 4
(STS2)
Check the signal contents by each digit of LED
using the following table.
@
There are three types of warnings as listed in the
table.
EO
IPF
E4
E7
WPE
NCE
INSTANTANEOUS
POWER FAILURE
PARAMETER
SETTING ERROR
NC EMERGENCY
STOP
Warning which is issued when the
power voltage temporarily drops.
/cl'
i..
y
12vJr
Lp>
/-
"",/.A
/c_*
[,A
Warning which is issued when a
parameter value exceeds the allow-
able range
OWarning which is issued when an
emergency stop signal is inputted
from the CNC in bus linkage with
the M300 series CNC.
owarning which is issued when an
emergency stop signal is inputted
from the outside while the exter-
nal emergency stop signal is
validated with the related para-
meter being set.
C
-9-

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi FREQROL-SF and is the answer not in the manual?

Mitsubishi FREQROL-SF Specifications

General IconGeneral
BrandMitsubishi
ModelFREQROL-SF
CategoryDC Drives
LanguageEnglish