(iii) After replacing the SF-OR (or
SF-ORlO)
card, assemble
the parts being disassembled in the reverse procedure
as the assembling procedure.
(Note) When mounting the card, by pushing the connec-
tor (rear side) from the front side with your
fingers and check that the connector is securely
connected to the card.
2.4.3
Replacing SF-TL card
.
Connector (Rear side)
/
/”
/
Termination
resistor-y)
L
\
Screw
“c3
/
/'
.'
/'
(
i) By referencing Appendix 2-3, remove the connectors
(CNlA,
CONB,
CONAA) and termination resistor
(CNlB).
(ii)
Loosen the five screws and remove the SF-TL card.
(iii) After the SF-TL card is replaced, assemble the parts
being disassembled in the reverse order of the
assembling procedure.
(Note) When mounting the card, by pushing the connec-
tor (rear side) from the front side with your
fingers and check that the connector is securely
connected to the card.
-
63
-
To Next Page
Loading...