Mitsubishi FREQROL-SF User Manual

3
Spindle orientation
control circuit
3 2 Control circuit and
parameter setting
3.2.2 Where the equipment is linked with the NC through the
bus (SF-TL card):
(1) Setting pins
Although all setting pins are described in Reference
1.1.3(3),
only the setting pins relating to the orien-
tation are listed in the following.
No.
Name
Setting
Description
I ! ,
Outputs an encoder
I',\ I
I.I'IL
feedback signal from
CONB to CONAA.
PIN 1
Outputs a feedback sig-
PIN 2
nal from the CON2 motor
IBare board
I',\ I
detector to CONNA.
CONNA output 'I"
drawing No.
However, the phase Z
52 is not
selection
outputs the linear zone
used.)
of the magnesensor.
outputs a feedback sig-
nal from the CON2 motor
detector to CONAA.
J
No power is supplied
I
from NC.
PIN 5
Orientation
encoder power
4
L
Power is supplied from
I
NC.
,',\',
-89-

Mitsubishi FREQROL-SF Specifications

General

Brand	Mitsubishi
Model	FREQROL-SF
Category	DC Drives
Language	English