EasyManuals Logo

Mitsubishi FREQROL-SF User Manual

Mitsubishi FREQROL-SF
219 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
1
1 Troubleshooting
~1
Table 1.3
Checking power voltage
Checking
Amplifier input pins
AC power voltage
Xl, X2, X3, and E
See Appendix l-l
Checking DC power
supply voltage on
Checking DC output
voltage at check
See Appendixes 5,
printed circuit
pins on SF-PW card
h(4),
and
g(4).
board
Table 1.4
Trouble classification
E;$-
cation
Situation
1
When the amplifier is powered on at the first
time,
it does not normally work.
1.2.1
2
The equipment which has normally worked does
not abruptly work.
1.2.2
A.
The equipment does not work in occasions.
The orientation stop position deviates from
3
the specific position.
Although an alarm
1.2.3
lights,
it is recovered by turning off and
then on the equipment or by resetting it.
When the power is turned on, the display of
1
the operation panel does not appear at all.
Alternatevely,
the DC voltage of the printed
1.3.1
circuit board is not correct.
When the power is turned on, the display on
the operation panel does not indicate
rota-
2
tions in the status display mode (as shown in
1.3.2
B
the following figure).
)-
::
The display on the amplifier printed circuit
board (SF-CA card) indicates an alarm (as
3
shown in the following figure).
1.3.3
Continued
on the next page.
1
r-
-3-

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi FREQROL-SF and is the answer not in the manual?

Mitsubishi FREQROL-SF Specifications

General IconGeneral
BrandMitsubishi
ModelFREQROL-SF
CategoryDC Drives
LanguageEnglish