Mitsubishi FREQROL-SF User Manual

@ Spindle parameter (l/2) screen
#
Parameter
Description Setting range (unit)
0: l/l
Encoder gear
11 sgear ratio
Sets the gear ratio between spindle and
1: l/2
encoder.
2: l/4
3: l/8
@I Spindle parameer (2/2) screen
CParameter No.
of parameter error
# No.
Parameter
Description
Setting range (unit)
Encoder spindle orientation:
Encoder Magnesensor
Spindle
The spindle rotational angle at which
orienta-
creep speed starts is set.
1 21 PGl &iz;;e;;F
Standard setting: 180
0 - 500 ms
tion
Magnesensor spindle orientation:
point
The time in which creep speed starts
after passing through linear zone is
set.
0 - 359cdeg.J
Standard setting: 133
Spindle
orienta-
2 22 PG2 ~~~~ie:~d
Angle at which creep speed run changes to
position control loop is set.
0 - 40tdeg.I
tion
Standard setting: 20
point
Spindle Encoder Magnesensor
orienta-
The error range within which spindle ori-
4 24 ZRZ tion, in-
entation complete signal is output is set.
position
Standard setting: 1.00 0 - 359tdeg.I
0 - 39tdeg.j
range
Spindle
5 25 OSP ;;;;nta-
Spindle orientation speed is set.
Standard setting: 220
0 - 1000 (rpm)
speed
6 26 CSP Creep
The creep speed is set.
speed
Standard setting: 20
0 - 1000 (rpm)
-91 -

Mitsubishi FREQROL-SF Specifications

General

Brand	Mitsubishi
Model	FREQROL-SF
Category	DC Drives
Language	English