Mitsubishi MELSEC-A series User Manual

8. TROUBLESHOOTING /MELSEC-A
Chock Raw
40
41
1 to400
Start number
0 to 19 Pointer
7
-
i
I 42 I
1 S~d change Starting bias speed to parameter speed
1 limit (Not 0)
H
t
I
I 0 to 1.62O.OOO.OOO I
I
I I
I Premnt value change
I 0 to 16,252,928 in PLS
in mm, inch, or degree
Jogspaed
I
Starting bias seed to parameter ios
speed limit (Not 0) I 'l I
-
L
When two axes are to be started at the
45
Start axis
polation start or for dual axis start.
The second axis must not
be busy or
same time, both must be set for inter-
Start axis
must be bchind the start point when an
interpolation start or
a dual axis start
is called.
-
46
L
*I: If the st wed exceeds the parameter rpaed limit value, positioning is controlled at
the parameter
wed limit value.
'2: If the units are mm, inch, or degree and tram1 per pulse is "a" (unit/PLS), the address
S range is restricted as given below:
S (unit)
a (unit/PLS)
16,252,928 (PLS)
Tabk 8.3 Data Ram Error Codes
t
i
t.
f
8-4
IS INN ffilO1-A
1
*
I

Mitsubishi MELSEC-A series Specifications

General

Brand	Mitsubishi
Model	MELSEC-A series
Category	Controller
Language	English