Mitsubishi Q2ACPU User Manual

13 - 6
13. PARAMETER LIST
* N and M indicate the following:
N: Number of the module counted from the first.
M: Network type
Setting
Reference Section/Reference Manual
Default value Setting range
–– –
No setting Empty/Input/Output/Special
Section 5.3
No setting 0 to 64 points (in 16-point units)
No setting 0 to 1FFF
H (in 10H units, hexadecimal)
No setting Up to 16 characters
No setting Up to 16 characters Section 5.3
–
For QnA/Q4AR MELSECNET/10 Network
System Reference Manual
For QnA/Q4AR MELSECNET/10 Network System
Reference Manual
MELSECNET, MELSECNET/B Data Link System
Reference Manual
M Network type M Network type M Network type
0
H MELSECNET/10 (Default) 7H MELSECNET (Local station)
D
H
MELSECNET/10 (Multiple remote
submaster, No remote master in the host
CPU module)
1
H MELSECNET/10 (Control station) 8H MELSECNET II mixed (Local station)
2
H MELSECNET/10 (Normal station) 9H MELSECNET II (Local station)
E
H
MELSECNET/10 (Multiple remote
submaster, There is a remote master in the
host CPU module.)
3
H MELSECNET/10 (Remote master station) AH MELSECNET/10 (Standby station)
4
H MELSECNET (Master station) BH MELSECNET/10 (Multiple remote master)
F
H
MELSECNET/10 (Parallel remote
submaster)
5
H MELSECNET II mixed (Master station) CH MELSECNET/10 (Parallel remote master)
6
H MELSECNET II (Master station)

Mitsubishi Q2ACPU Specifications

General

Brand	Mitsubishi
Model	Q2ACPU
Category	Controller
Language	English