−3−
WARNING
Do not install the unit in appropriate environment or where
inflammable gas could generate, flow in, accumulate or leak.
If the unit is used at places where air contains dense oil mist, steam, organic solvent vapor,
corrosive gas (ammonium, sulfuric compound, acid, etc) or where acidic or alkaline
solution, special spray, etc. are used, it could cause electric shocks, break-down, smoke or
fire as a result of significant deterioration of its performance or corrosion.
Do not install the unit where water vapor is generated excessively or
condensation occurs.
It could cause electric shocks, fire, or break-down.
Do not use the unit in a place where it gets wet, such as laundry
room.
It could cause electric shocks, fire, or break-down.
Do not operate the unit with wet hands.
It could cause electric shocks.
Do not wash the unit with water.
It could cause electric shocks, fire, or break-down.
Use the specified cables for wiring, and connect them securely with
care to protect electronic parts from external forces.
Improper connections or fixing could cause heat generation, fire, etc.
Seal the inlet hole for remote control cable with putty.
If dew, water, insect, etc. enters through the hole, it could cause electric shocks, fire or
break-down.
If dew or water enters the unit, it may cause screen display anomalies.
When installing the unit at a hospital, telecommunication facility, etc.,
take measures to suppress electric noises.
It could cause malfunction or break-down due to hazardous effects on the inverter,
private power generator, high frequency medical equipment, radio communication
equipment, etc.
The influences transmitted from the remote control to medical or communication
equipment could disrupt medical activities, video broadcasting or cause noise
interference.
Do not leave the remote control with its upper case removed.
If dew, water, insect, etc. enters through the hole, it could cause electric shocks, fire or
break-down.
To Next Page
Loading...
Need help?
General
