4. DATA INPUT/OUTPUT
4.2.4 Communication command (I/O format)
1 Measurement command
Operation content
Input
(External device -> this instrument)
Output
(This instrument -> external device)
Zero-setting
(Moves to the INC
system)
CR**CRLF
CH**CRLF
DH**,PRESETCRLF
（*Refer to the “NOTE” below）
Moves to the Preset
system
DS**,PCRLF
DH**CRLF
Preset value setting
CP**,+0016.2345CRLF CH**CRLF
Measurement
system
Preset value output
DP**,OUTCRLF DH**,+0016.2345CRLF
Normal
CN**CRLF
Max.
CX**CRLF
Min.
CM**CRLF
Measurement
mode
switching
TIR (Run-out)
CW**CRLF
CH**CRLF
Normal value
GN**,+0016.2345CRLF
Max. value
GX**,+0016.2345CRLF
Min. value
GM**,‑0016.2345CRLF
Data output
TIR (run-out) value
GA**CRLF
GW**,+0016.2345CRLF
Cancel
(Peak hold start)
CL**CRLF CH**CRLF
Peak hold
Peak zero set
DS**,XM‑ZEROCRLF DH**CRLF
Judgment ON
DJ**,ONCRLF
Judgment cancel
DJ**,OFFCRLF
DH**CRLF
Upper limit value input
CG**,+0016.2345CRLF
Lower limit value input
CD**,‑0016.2345CRLF
CH**CRLF
Upper limit value output
DJ**,GOUTCRLF DG**,+0016.2345CRLF
Lower limit value
output
DJ**,DOUTCRLF DD**,‑0016.2345CRLF
Result output (OK)
DH**,OKCRLF
Result output (+NG)
DH**,+NGCRLF
Result output (-NG)
DH**,‑NGCRLF
Tolerance
judgment
Status output
(under cancel)
DJ**,OUTCRLF
DH**,JOFFCRLF
Analog display
Centering
DA**CRLF DH**CRLF
Lock
DF**,LOCKCRLF
Cancel
DF**,FREECRLF
DH**CRLF
Status output
(under lock)
DH**,F‑LOCKCRLF
Function lock
Status output
(under cancel)
DF**,OUTCRLF
DH**,F‑FREECRLF
NOTE
•
•
•
•
•
For the detail of each item in the operation content, refer to Chapter 3.
“CRLF” represents “CR” (carriage return) and “LF” (line feed).
“＊＊” indicates an ID No. For information about ID No. setup method of this instrument,
refer to section 3.2.
Set an ID No. between 00 and 99.
Digimatic indicators with a specified ID No. between 01 and 99 can receive and execute a
No. 99MAH016B
4-5
To Next Page
Loading...
