Mobileye 6 - Mobileye 6 Connections Description; Mobileye 6 Main Unit Connections

Technical Support
Mobileye 6  Technical Installation Guide_Rev0.3
Feb, 2016
Page 12 of 65
Mobileye Proprietary and Confidential
support@mobileye.com
2.2 Mobileye 6 Connections Description
The following paragraphs describe in detail the function of the cables and
connections shown above.
2.2.1 Mobileye 6 Main unit connections
The Mobileye 6 main unit contains the camera, the Audio Buzzer and the main
processor (Eye The Mobileye 6 main unit also contains volume control buttons.
The Mobileye 6 Main unit functions as a Universal Mounting Adapter for all 
front windshield angles.         with the
provided 3M double sided sticker.
The Mobileye 6 Connecting cable is split into a few various cables which are used to
connect to the vehicle power source, to the vehicle CAN-bus, to the vehicle High-
nalog Left
and Right Turn indicator signals via Diode) and to the Mobileye EyeWatch display
and Control unit and Mobileye EyeCAN.
A detailed description of each Mobileye 6 connecting cable connections can be
found in the table below:
Wire Name & Function
Wire color
Connector
Connection To
EyeCAN - ( 6 pin connector)
Black
P2
EyeCAN unit (for system calibration)
EyeWatch - (4 pin connector)
Black
J1
EyeWatch Display & Control unit
BAT+ (12/24V)
Red
-
Vehicle constant power (Battery)
GND
Black
-
Vehicle GND (BAT-)
Ignition (12/24V)
Blue
-
Vehicle Ignition signal
CAN B H
White
-
Vehicle CAN-bus (CAN High wire)
CAN B L
Yellow
-
Vehicle CAN-bus (CAN Low wire)
IHC  (Analog Output)
Gray
-
Vehicle High-beams via external Relay
or connection to any 3
rd
party device
AUX (Analog Input)
Pink
-
1 analog Signal Input (or both Left and
Right Turn indicators analog input via
Diode)
Table 1: Mobileye 6 connecting cable connections