Mobileye Proprietary and Confidential
support@mobileye.com
4.2.5 Calibration Method
You now will be asked to choose your Calibration method.
1- TAC
System will be calibrated manually at installation site without the need to move
the vehicle.
If you choose TAC you will be directed to the next step which is Camera Calibration.
Follow the online Wizard instructions as explained in the next pages.
2 – Automatic Calibration
System will automatically calibrate during your first drive (between 5 to 10
minutes)
If you choose Automatic Calibration you will be directed to the "Signal Test &
Configuration" step or to the "Alerts configuration" step (if you have suitable user
permissions see section 4.3.9 or 4.3.10).
Note:
If you choose Automatic Calibration you must complete the Calibration Procedure
with a Calibration Drive.
To Exit the Automatic Calibration mode you will need to restart the Mobileye Setup
Wizard and follow the online instructions.
The full Mobileye Automatic Calibration – User Manual can be downloaded here.
To Next Page
Loading...
